Use a force sensor

Connect a Tindeq Progressor or similar sensor to measure finger tests and hangboard sessions live.

iPhoneAndroid

A force sensor such as the Tindeq Progressor or a Crimpdeq measures how hard you pull, about 80 times a second. Crux reads it over Bluetooth during tests, hangboard sessions and block lifts.

Steps

  1. Open Settings, Watch and devices, then Force sensor.
  2. Press the sensor’s button until it blinks. Crux lists sensors in reach.
  3. Tap Connect. Pick the model so Crux knows its limit.
  4. Hang nothing on it and tap Tare (zero it).

What you’ll see

A live reading, the battery and the firmware. In a test, a 3-2-1 count, then the force drawn as you pull, with a gold line at your peak and last time’s best dashed.

With a watch workout running, the reading shows on your watch too. To show it on any other exercise, tap “…” in Active mode, then Show the force sensor.

Readings go to whoever’s phone runs the test, and nothing is stored on the sensor, so a borrowed sensor is fine. See the privacy policy for what Crux keeps.

If it doesn’t work

It isn’t listed. Close the Tindeq app: a sensor talks to one app at a time. Check Bluetooth is on and the sensor is charged; it turns itself off after 10 minutes unused.

It says Not supported yet. Crux reads the Tindeq Progressor and the Crimpdeq. Other makers’ sensors, like the Hangman, use their own protocol.

A try wasn’t kept. Readings above the sensor’s rated load aren’t kept, so a Progressor 200 can’t record a 250 kg pull.

Last checked 19 November 2026.

Still stuck?

In the app, open Settings, then Help and support, and tap New request. Or email support@cruxlog.app with what happened, your phone and the date of the session.